PME SETUP FILE 32Bit Created: 2011-10-26 12:47:46 Device ID (Address) 110 S/N: 150120105 Hardware version: 2.06 Firmware version: 2.06 CAN-Baud rate: 0 Keaboard active: No Sensor type: Full bridge Shunt: --- Supply voltage 5 V Input range 3 mV/V Filter characteristics Bessel Filter frequency 1 Hz Zero value 0 kg .49147 mV/V Nominal value 10 kg 2.9375 mV/V 1st calibration pt.: 0 kg .49147 mV/V 2nd calibration pt.: 1 kg .78522 mV/V Display precision 0.000 Step 1 Zero balance: 0 kg Zero ref. 0 kg Tare value: 0 kg Limit values 1 Signal source Gross Limit value monitoring ON Switching direction Level overflow Switch level: 10 kg Switch hysteresis: .5 kg Switching delay positive: 0 ms Switching delay negative: 0 ms Limit values 2 Signal source Gross Limit value monitoring ON Switching direction Level overflow Switch level: 10 kg Switch hysteresis: .5 kg Switching delay positive: 0 ms Switching delay negative: 0 ms Limit values 3 Signal source Gross Limit value monitoring ON Switching direction Level underflow Switch level: -10 kg Switch hysteresis: .5 kg Switching delay positive: 0 ms Switching delay negative: 0 ms Limit values 4 Signal source Gross Limit value monitoring ON Switching direction Level underflow Switch level: -10 kg Switch hysteresis: .5 kg Switching delay positive: 0 ms Switching delay negative: 0 ms Peak value : Input signal MIN: Gross Input signal MAX: Gross Envelope discharge 0 kg/ s Digital outputs: Output0: Error neg. logic Output1: Inactive pos. logic Output2: Inactive pos. logic Output3: Inactive pos. logic Digital inputs: Remote control on Tare: Input 2 Peak value Max / MomValue: Inactive Peak value Min / MomValue: Inactive Hold peak value Max: Inactive Hold Peak value Min: Inactive Set zero Input 1 Set Parameter Set Bit 1: Input 3 Set Parameter Set Bit 2: Input 4 Analog out: Source: Gross Zero value: 0 kg 0 mA (range: +/- 20 mA) End value: 1 kg 20 mA (range: +/- 20 mA) Motion control: status Inactive Delay 500 ms Amplitude 1 kg PDO message: PDO value 0 by User Format 4 Byte Integer Intervall 0 ms Lock dialogs: Deactivate password input locked Dialog unlocked Parameter set unlocked Display unlocked Transducer unlocked Signal conditioning unlocked Analog out unlocked Limit values unlocked Peak values unlocked In-/Output unlocked CAN-Bus unlocked Additional functions unlocked Signal conditioning unlocked